Precision 20 mm bench dog to fit holes in the MFT. It is used to accurately align guide rail and align workpiece for perfect crosscuts or 45 degree miters. The dog's small height above the table allows them to be used with anything thicker than 12 mm.
Can also be used to hold a workpiece while sanding or glueing. Two pairs can be used with one pair in a vertical column and the other pair in a horizontal row to align workpiece square or to test for squareness.
These dogs are made from aircraft grade aluminum and anodized black. The package consists of 2 (1 pair) Qwas Dogs.
20 mm bench dog to fit in the holes on the MFT and in the slot on the bottom of a guide rail. Allows for quick accurate alignment of guide rail to the MFT holes. These dogs are made from aircraft grade aluminum and anodized black. The package consists of 2 (1 pair) Rail Dogs.
The Combination, or Combo, Pack consists of 1 pair of Qwas Dogs and 1 pair of Rail Dogs.
The most popular pack since it contains everything you need for maximum benefit of the MFT holes. The Super Pack consists of 2 pairs of Qwas Dogs and 1 pair of Rail Dogs.
A guide rail attachment to allow quick accurate crosscuts without the MFT. Great for cutting full plywood sheets. It is a right angle fence that slides onto a guide rail. Made from stiff aluminum plate and anodized black. Please note that it requires removing 10-12" of rubber from the bottom of your guide rail. Can also be used as a very accurate 30/60 degree right triangle.
Taper Dogs (Coming Soon)
The Taper Dogs are for securing something to your MFT table. That something can be a fence, a stop, a bench clamp, a vacuum port, or a jig. The 5/16" hole allows for a 1/4 or 5/16", 6 or 8 mm to pass through the dog and secure to your item.The bolt can tightened to draw your item tightly to the MFT top. These dogs are made from aircraft grade aluminum and anodized black. The package consists of 2 (1 pair) Taper Dogs. Due to the multitude of configuration possibilities, no screws or bolts are included with the Taper Dogs.